whats Wrong with the AE's Pointing Up like that?...i like em like that...in fact thats the Way i see then all the Time...everywhere i go....but its mainly the 115's i see tilted up like this...the 113's are more Level...but i do see Level 115's....im not sure if the 125's have Level Steps but i never see those Pointed Up...always level unless the Arm is Tilted at an Angle.

trust me its big wrong! I have seen some installations that actually lights up the grass in front of them instead of the road when they are shoved it in....I've seen some pointed up a bit higher than this one...

Hmm. I see. Why doesn't the M-250r2 have the problem when it has the same step mount design? I don't get it.

That is Odd.....Prehaps its the Lineman?

It isn't exactly the same design....there may also be something on AE that you would accidentally insert it farther.....I have been told by my lineman friend that the AE mounting thing is a problem....

Well the lights that I know of tilted are lighting a wide road from only one side thats why there tilted, but I do understand that it is often is laziness

I know some lazy linemen can tilt up an M-400 r2! (or a2, since same housing) I seen a case of a tilted up M-400 r2. Got one of those on kipling. I actually tested this with my pipe, and it seems that people can be lazy and force the arm on top of what is supposed to stop it! And that makes it tilt up very much.

Yep according to the instructions there is a way to tilt up fixtures with 4 bolt slipfitters, you have to tighten the front bolts more then the back or something like that

This 115 got replaced with an M-250r2. 250w HPS again.

Did the 115 fail or fall? xD Cause it kinda looks like its not fully on the arm.

Maybe both though it likely did fail, 250 watt 115s seem to do that a lot.

Maybe. xD But why replace it with another small fixture again? xD

One word; cheaper

I think Colorado state uses 250w HPS in medium fixtures. But Xcel energy uses small fixtures in 250w HPS.

We use small for all wattage (70/150/250/400) in OVZs, OVXs and 115s, though reacentally I have noticed a few 125s being installed for 400 watt instillations.

Yeah I see. there are no 400w HPS 115's or M-250r2s here.

And I did spot a 200w HPS 125 on the road. Dunno why 200.

We have no 400 watt 115 either since all of our lights are 120 volt, in the past a few (really 3 that I know of) 400 watt HPS M250R2.

Yeah. There are no 400w Small fixtures at ALL in Denver. the highest in small fixtures goes to 250w. That's it. 400w Fixtures get to be medium.

200 and 250 in small fixtures is a bad enough idea,400 is terrible.

Yeah. They should have all 250w HPS fixtures in Medium fixtures.

And 200 since they use the same lamp size size